How To Use Bathmate Penis Pump

Bathmate is very easy to use and you can get started in just a few seconds after your enlargement device arrives. Just make sure that you read all of the instructions first so you always enlarge your penis safely!

Bathmate in the Bathtub

The best way to use it is in the bathtub. First, fill up the tub and get ready to relax. Then, fill the Bathmate with water. While it is underwater, put your penis into the hollow chamber and pull it towards your body. Bathmate should be snug against your pubic area. You will need to pump the Bathmate a few times. As you pump, you will notice some water leaving the pressure release valve at the top of the device and pressure building up on your penis. At this point, you don’t have to keep Bathmate submerged underwater anymore. Keep pumping until the pressure is comfortable or until no more water leaves the pump.

Once you have it on and it is suctioning your penis full of blood, you can just sit back and relax in the tub. About every 5 minutes, pump it a few more times. Because it makes your penis get larger, more water will be able to come out. When you want to remove it, just active the pressure release valve. Ideally, it should be used at least 3 times a week (for better results, use it daily) for 15 minutes each session. Learn more at http://austingosser.bcz.com

In the Shower

You can also use it in the shower if you don’t want to bother filling up the tub. It is best to shower for a few minutes first though because the hot water will get the blood circulating to your genitals. Fill up the Bathmate chamber while you are holding the end so no water escapes.

With the Bathmate angled downwards (to keep water from spilling out), put your penis into the penis pump chamber. Pull the device towards your pubic area and pump it a few times. The pump should suction on your body, becoming sealed in place. Then, follow the instructions as if you were in the tub.

Cleaning 

It is very easy to keep clean and the device even comes with sterilizing tablets and a cleaning brush. All you need to do is fill a basin or your sink with warm water and then drop one of the sterilizing tablets inside. Then, put the device into the water and let it sit for about 20 minutes. To really get your Bathmate clean, you can push the pump on the side of the basin and pump it a few times.

This will make the pressurized water flow through the release valve and clean off any residue. The Bathmate cleaning brush is made to fit the device perfectly. Just wish it inside and rinse the device with water. If you are using Bathmate with lubricant, make sure to use a water-based lubricant. Oil-based lube is much more difficult to clean and could create a residue in the Bathmate.